①
-INTERFACE: This interface provides all control signals, including: RS232 communication,
laser on/off control, laser remote control mode selection, analog control, modulation signal, Interlock
interface, etc.This socket comes with a protective cover and a lock. When you are not using the product,
you can cover the power input socket with the protective cover and lock it with the lock.
②
-BREAKER: The circuit breaker (air switch) on the rear panel of the laser is the main power
switch of the laser.
③
-AC INPUT: The power input socket must be matched with the plug provided by us. This socket
comes with a protective cover and a lock. When you are not using the product, you can cover the power
input socket with the protective cover and lock it with the lock.
④-FIBER WATER IN: Output optical cable water inlet interface, this interface is connected to the
water outlet of the normal temperature water of the water cooler, and connected to the φ13 inner diameter
water pipe.
⑤
-FIBER WATER OUT: Output optical cable water outlet, this interface is connected to the
output optical cable water inlet, connected to the φ13 inner diameter water pipe.
⑥
- TOP WATER IN: The water outlet of the laser, this interface is connected to the cooling water
return port of the water chiller, and connected to the φ32inner diameter water pipe.
⑦
-TOP WATER OUT: The water inlet of the laser, this interface is connected to the water outlet
of the cooling water of the water chiller, and connected to the φ32 inner diameter water pipe.
⑧
-BOTTOM WATER OUT: The water inlet of the laser, this interface is connected to the water
outlet of the cooling water of the water chiller, and connected to the φ32 inner diameter water pipe.
⑨
-BOTTOM WATER IN: The water inlet of the laser, this interface is connected to the water
outlet of the cooling water of the water chiller, and connected to the φ32 inner diameter water pipe.
4.3 Power Connection
CAUTION:
(1) Before connecting to the AC power supply, please check whether the supplied AC
power supply meets the requirements in Table 1;
(2) Incorrect wiring will cause damage to the laser, so please check whether the power
cord is connected correctly before powering on the laser.
The power cable provided by the company should be directly connected to the AC INPUT interface
on the rear panel of the laser.
The definition and parameter requirements of AC INPUTline interface are shown in Table 5
Table 5 The definition and parameter requirements of AC INPUTline
To Next Page
