i) Click the laser “ON”.
6.2 Laser Operating in External Control Mode
Figure 16 The wiring diagram of laser operating in external control mode
Operations Steps
a) Turn the knob switch on the rear panel to“ON”
b) Turn the key switch to“ON”
c) Open the Raycus software
d) Click the guide laser “ON” button to view the guide laser
e) Turn off “AD” mode and turn on “External Control” mode (this mode can be memorized after
power off)
f) Click the main power “ON”
g) Waiting for “Ready”
h) Set the percentage of laser emission power
i) Turn on the laser through the high level output by MOD signal
To Next Page
