Raymarine E120W - Page 198

182 E-Series Networked Display Reference Manual
Cycling through the video inputs
You can set up your video application to automatically cycle through the images being
received. This is particularly useful if you have on-board cameras and wish to use them
to obtain a regular overview of your boat, engine room etc.
Setting up a video cycle
To specify which video inputs are to be included in the cycle and their order:
1. Open the Video Setup Menu, as described on
page 180 .
2. Highlight and select Cycle 1:
3. Repeat this process for Cycle 2, 3 and 4.
Note:
If you wish to exclude an input, switch its status to NONE.
Setting up the cycle period
By default the cycle period is 10 seconds. This can be changed (1to 99 seconds) if
required.
To specify the number of seconds between shots in the cycle:
1. Open the Video Setup Menu, as described on
page 180 .
2. Specify the cycle period:
D7489-2
Engine room Bridge Aft Stern PRESENTATION
D8494_1
Select CYCLE 1
Video Setup Menu
Cycle 2 Bridge
Cycle 3 Aft
Cycle 4 Stern
Cycle Period 10secs
Cyc
l
e 1 En
g
ine Roo
m
Select required
input for Cycle 1
Engine Room
Bridge
Aft
Stern
None
OK
x2
D8499_1
Select CYCLE PERIOD
Video Setup Menu
Cycle 1 Engine Room
Cycle 2 Bridge
Cycle 3 Aft
Cycle 4 Stern
Video 1... COMPOSITE VIDEO 1
Video 2... COMPOSITE VIDEO 2
Video 3... COMPOSITE VIDEO 3
Video 4... COMPOSITE VIDEO 4
C
yc
l
e Perio
d
10
sec
s
Highlight CYCLE PERIOD
1
7
s
OK
x2
Example:
Adjust value
as required