Setting Up the VCR
Startup
8
5. Use the on-screen menu system.
Point and Select is the method you use to move
through the menu system. There are two ways to select
(or change) a menu or feature.
• Using the ARROW Buttons: Press the MENU button
to display the VCR MAIN MENU. Then use the UP or
DOWN ARROW button to point to a menu or item.
Use the LEFT ARROW to move left and the RIGHT
ARROW button to move right on a line. Press
ENTER to select (or change) the item.
• Using the Number Buttons: Press the MENU button
to display the VCR MAIN MENU. Then press the
number button on the remote that corresponds to the
number on the menu to select (or change) an items.
Using the number button allows you to point and
select a menu item at the same time.
Although there are two ways to access the menu
system, only the ARROW buttons are referenced when
explaining the VCR features and operations. The
ARROW buttons are easier to access because the
number buttons are located behind the remote door.
6. Select the signal type.
Before channels can be added into the VCR’s channel
memory, the signal type (ANTENNA, CABLE or CABLE
BOX) must be selected. If the ANTENNA/ CABLE SET
menu did not appear when you first turned on your
VCR, follow these directions.
A. Press MENU to display the MAIN MENU. If this
menu does not appear:
• Make sure TV is tuned to same channel as
CH 3
56
4switch on the back of the VCR or the
TV’s video input (refer to TV’s manual).
• Press SELECT VCR, then press MENU again.
• If you use a basic hookup, check VCR indicator in
display panel – it should be on. Press TV•VCR to
turn it on.
• Check the connections.
B. Press the DOWN ARROW to highlight
“Antenna/Cable set,” then press ENTER.
C. Use the RIGHT ARROW to select the signal type.
For Cable Box selection, channel memory is not
available. See step 11 on page 11.
D. Follow the on-screen instructions.
To Next Page
Loading...
