IN FROM ANT.
A. Basic hookup.
Use this hookup for a simple connection
which requires fewer accessories.
1. Set the CH 3
55
66
4 switch on back of VCR
to either channel 3 or 4.
You will tune the TV to this channel and use the
TV•VCR button to watch the VCR.
2. Connect as shown.
This connection may require additional
accessories not provided.
3. Plug in power cords of VCR, TV, and
cable box.
4.
B. Advanced hookup.
Use this hookup for slightly improved
picture quality, Hi-Fi, stereo playback and
more convenient operation — use of TV•VCR
button not required.
1. Connect as shown.
This connection requires additional accessories
not provided.
If your TV is not stereo, you may need a
Y-adapter to hear sound from both channels.
2. Plug in power cords of VCR, TV, and
cable box.
3.
You will tune the TV to its video input to
watch the VCR.
Cable Box Adapter Hookup
Use this adapter if you have a wireless
remote controlled cable box. You can tune
the cable box to the channel you want to
record or watch with the remote. Refer to
step 11, page 11 for setup.
1. Connect the cable box adapter to the OUT
TO CABLE BOX jack on the back of the
VCR.
2. Position adapter on top of the cable box.
Make sure it is properly positioned so the sensor
on the bottom can send signals to the sensor
area of the cable box. You may want to test the
adapter before removing the adhesive for
permanent placement.
Continue to page 7.
Continue to page 7.
A
B
To Next Page
Loading...
