PRE-AMP GAIN
The pre-amplifier range and default value depend on the attached expander. To adjust amplification levels, follow the
instructions below:
1.
Go to Menu > Settings > Audio > Control > Pre-Amp Gain.
2.
Move the Pre-Amp (pre-amplifier) sliders up and down to adjust the amplification levels.
3.
To link the amplification for each channel, select Link.
Figure: Pre-Amp Gain
C OPYRI GHT © 2017 R ED.C O M , I NC 955- 01 38 _V6.3, REV-D | 159
WEAPON/EPIC-W OPERATION GUIDE
To Next Page
Loading...
