Redline Communications RDL-3000 User Manual

Ellipse INSTALLATION GUIDELINES
70-00159-01-09 Proprietary Redline Communications © 2015 Page 20 of 52 April 29, 2015
3.1 General Information
The General Information fields uniquely identify each installed system. It is
recommended to record this information prior to installation.
Table 6: Site Survey: General Information Settings
Setting
Radio Management
Name
Details
Location
Contact
3.2 Network Settings
The Ellipse must be assigned a unique IP addresses before it is connected to the base
station and the local area network (LAN). When DHCP is enabled, the remaining
settings are populated automatically by the DHCP server.
Table 7: Site Survey: Network & Syslog Server Settings
Setting
Radio Management
DHCP Enable
IP Address
Subnet Mask
Default Gateway Address
Ethernet Mode
3.3 Radio Management Settings
The following table contains the minimum set of parameters required to configure the
wireless interface. Note that these settings are made independently of the Serial
Gateway settings using the Radio Management selection.
Table 8: Site Survey: Radio Management Settings
Parameter
Value
System Name
TCP/IP Address
Channel Size
RF Freq.
Tx Power
Antenna Gain (DFS only)
Path Profile
The path profile should include the following information:
Table 9: Site Survey: Path Profile Data
Site Location
Antenna Height
Antenna Azimuth
Antenna Elevation
Expected RSSI

Redline Communications RDL-3000 Specifications

General

Brand	Redline Communications
Model	RDL-3000
Category	Controller
Language	English