Ellipse INSTALLATION GUIDELINES
70-00159-01-09 Proprietary Redline Communications © 2015 Page 21 of 52 April 29, 2015
RF Interference
Frequency planning is an essential component of installation and it is very important to
test for RF interference at every installation site. The system will not achieve full
operational capability if there is excessive interference on the same or adjacent RF
channel. Use the built-in spectrum sweep feature to determine if a selected RF channel
is generally free from interference.
Figure 8: Site Survey: Ellipse Antenna Position
IMPORTANT: Refer to site survey cell plan for details about collocating multiple sector
antennas on a tower/mast. Recommended antenna spacing is dependent on frequency.
Figure 9: Site Survey: Ellipse Antenna Position
To Next Page
Loading...
Need help?
General