Reer MOSAIC M1S Installation And Use

MODULAR SAFETY INTEGRATED CONTROLLER MOSAIC
8540780 • 10/07/2020 • Rev.38 169
English
Voltage sensors: voltage limits
With the following parameters you can limit the measurement range by setting a
minimum and a maximum permissible voltage:
 Minimum voltage: The value is set to 0 V and cannot be changed.
 Maximum voltage: The range for the maximum permissible voltage is 10,05 VDC to
11,5 VDC.
If the measurement values are above the maximum value, then the MA2/MA4
module detects a anomaly and raise diagnostics.
The following table summarizes MA2/MA4 module behaviour as a function of
measurement values.
Measurement value (A)
Diagnostic
(A) < Minimum voltage limit
NO
(A) > Maximum voltage limit
YES
Minimum voltage limit < (A) < Maximum voltage limit
NO
Division anomaly: division saturated at 0 or 200000
This option let you to choose which value the MA2/MA4 module will force to the
division when a mathematical error is detected.
Analog Output
If this option is selected, the raw values of the measurements are available within
MSD by using the Graphical Monitor.
This is graphically represented on the function block by a light green square and
the label Analog.

Reer MOSAIC M1S Specifications

General

Brand	Reer
Model	MOSAIC M1S
Category	Controller
Language	English