Renishaw NC1 User Manual

8
Service subroutine features
The measuring and calibration subroutines are supported by the
service subroutines listed below.
n L9760 – used for the settings data.
n L9761 – used for startup functions.
n L9762 – used for the measuring routine.
n L9763 – used for the G31 routine.
n L9764 – used for the G0/G1 routine.
n L9765 – used for the G2/G3 routine.
n L9766 – used for the search routine.
n L9769 – used for error messages.
n L9800 – clears global ‘R’ parameters used for subroutine input
data.
NOTE: L9800 Clear global ‘R’ parameters.
The subroutine L9800 is called at the end of every measuring and
calibration subroutine (9800-series) to reset the global ‘R’
parameters, used as inputs, to a default value.
If global ‘R’ parameters R00 to R26 are used for other
programming purposes outside of this tool setting package, it is
recommended that L9800 is called prior to setting them for the
next tool setting routine. All examples in this programming guide
show this being done.
Software features

Renishaw NC1 Specifications

General

Brand	Renishaw
Model	NC1
Category	Measuring Instruments
Language	English