20
Customising the subroutines
In addition to the subroutine customising information described below,
further customising and installation information is included in the
Readme file supplied with the NC1 software.
Editing the measure move subroutine L9762
The back-off move distance can be adjusted for optimisation of the
cycles. The tool must retract out of the beam otherwise the ACTIVE
BEAM CUT alarm will result.
Sample of subroutine L9762
RENL[6]=1.5; EDIT BOF
Customising the subroutines
To Next Page
Loading...
Need help?
General
