Renishaw NC1 - Subroutine inputs

81
For spindle axis temperature compensation
R02=4. R03=c R06=k [R17=q R19=s R25=y]
L9861
where [ ] denotes optional inputs
Example R02=4. R03=3. R06=88. R17=5. R19=2500 R25=5.
L9861
For radial measuring axis temperature compensation
R02=5. R03=c R18=r [R17=q R19=s]
L9861
where [ ] denotes optional inputs
Example R02=5. R03=3. R18=6. R17=5. R19=2500.
L9861
Subroutine inputs
The following inputs are used with this subroutine:
R02=4. Temperature compensation tracking in the spindle axis.
This performs a beam find and length measurement in
the spindle axis only.
R02=5. Temperature compensation tracking in the radial-
measuring axis. This performs a beam find and radial
measurement only.
R02=6. Temperature compensation tracking in both the spindle
axis and radial-measuring axis. This performs both
operations described for inputs R02=4. and R02=5.
Temperature compensation tracking