2
Caution – Laser safety
The laser used in the Renishaw NC1 non-contact tool
setting system emits visible red light at a wavelength of
670nm and has a maximum power output of less than
1mW. It is a Class 2 product as defined by European and
American laser safety standards (EN60825-1:1994 and US Code of
Federal Regulations 21CFR1040).
When using the NC1 system:
n
Do not stare directly into the laser beam. The beam may be
viewed safely from the side.
n
Ensure that the laser beam is not reflected into the eyes of
another person via a mirror or other reflective surface.
n
Do not expose skin to the laser beam for longer than is absolutely
essential.
n
When the system is not being used, cover the laser beam
aperture with the sliding cover.
Caution – Software safety
The software you have purchased is used to control the
movements of a machine tool. It has been designed to
cause the machine to operate in a specified manner under
operator control, and has been configured for a particular
combination of machine tool hardware and controller.
Renishaw has no control over the exact program configuration of the
controller with which the software is to be used, nor of the
!
Cautions
To Next Page
Loading...
Need help?
General
