Renishaw NC1 - Editing subroutine L9760

18
RENT[28] M code number to disable the latch mode. If the latch
mode feature is not to be used, enter 9 to select M9
coolant off (or similar).
RENT[29] M code number to enable the latch mode. If the latch
mode feature is not to be used, enter 9 to select M9
coolant off (or similar).
Editing subroutine L9760
Before running the cycles, edit the settings data between block
numbers LN1 and LN2 .
First, enter the metric/inch units factor (1. or .04) in parameter
RENC[7]. Next, enter data in the other parameters using the same
units.
Sample of subroutine L9760
LN1:
RENC[5]=1; RETRIES
RENC[6]=-1.; SAFE RETURN POSITION
RENC[7]=1; UNITS FOR DATA 1MM .04INCH
RENC[9]=1; OFFSET-RADIUS 1/DIAMETER 2
RENC[10]=200.; MAX TOOL LENGTH (8.0 in)
RENC[11]=70.; MIN TOOL LENGTH (2.75 in)
RENC[12]=80.; MAX CUTTER DIAMETER (3.15 in)
RENC[13]=2; TL SET RADIUS MEAS DIR
RENC[14]=2; CALIB RADIUS MEAS DIR
RENC[15]=.10; NC1-DELAY IN SECS
RENC[17]=5.; DEFAULT OVERTRAVEL (0.197 in)
RENC[18]=.002; MEASURE RESOLUTION (0.0001 in)
Setting-data subroutine