88
Error messages and alarms
Message TOOL OUT OF RANGE
Meaning Either the size of the cutting tool exceeds the size that is
set in parameters RENC[10] to RENC[12] inclusive, or the
tool offset number is wrong.
Action Edit the program. Check the cutter size.
Message RUN-OUT/EDGE MISSING
Meaning A cutting edge is missing or damaged, or the tool is
eccentric.
Action Replace or adjust the defective tool, or modify the
tolerance value.
Message BROKEN TOOL
Meaning The tool is out of tolerance.
Action Replace the defective tool and establish the correct tool
offset value.
To Next Page
Loading...
