Renishaw NC1 - Relative to a master tool with zero (0) tool-offset value.

11
RENC[10] = –800.0 Maximum length tool
RENC[11]= –950.0 Minimum length tool
Relative to a master tool with zero (0) tool-
offset value.
The master tool-offset register is set to zero (0) and all other tool-
offset registers are set as ± values relative to the master tool.
Example
Home position, to the zero (0) position of the part
program = –1000 mm (but this is not important)
A master calibration tool of 150 mm is used (offset register
value = 0).
The longest tool for the machine is 200 mm long.
The shortest tool for the machine is 50 mm long.
Parameters RENC[10] and RENC[11] must be set in the Setting-data
subroutine (L9760). Set them as follows:
RENC[10] = 50.0 Maximum length tool
RENC[11] = -100.0 Minimum length tool
Measurement values used in this guide
Throughout this guide, metric units of measurement, i.e. millimetres,
are used in the examples. The equivalent imperial measurements, i.e.
inches, are shown in brackets.
Tool-offset types supported