Renishaw NC1 User Manual

36
RENT[23] X or Y-axis position of the beam, when measured from
the negative side of the beam.
RENT[24] Position at which the beam is measured.
RENT[26] Spindle (length-measuring) axis temperature
compensation zero offset.
RENT[27] Radial-measuring axis temperature compensation zero
offset.
Alarms
The following alarms may be generated when this cycle is executed.
ACTIVE BEAM CUT
BEAM NOT CUT
FORMAT ERROR
OUT OF TOLERANCE
For an explanation of the meaning of alarms, see “Error messages
and alarms” on page 85.
Example
Calibration
Using a calibration tool T1, which is 88.0 mm (3.46 in) long and
6.0 mm (0.236 in) diameter.
%_N_????
T1
M6
D1
Calibrating the NC1

Renishaw NC1 Specifications

General

Brand	Renishaw
Model	NC1
Category	Measuring Instruments
Language	English