RC4500 Antenna Controller Chapter 5 MODES – In Depth Descriptions
113
RESET CODE: 0 CONFIG-DEFAULTS
5.2.1.3.12 Reset Defaults
<5 DIGIT CODE>RESET TO FACTORY DEFAULTS
The CONFIG-DEFAULTS screen is used to reset the controller's memory. Access to this item is allowed
only when the Expert Access level is set to SUPER-USER. To reset the system memory, the user must
key in a 5 digit code followed by the ENTER key.
NOTE: The reset code is the same as the INSTALL level Expert Access code given in Appendix A. This
appendix may have been removed by a system manager to limit use of the codes.
To Next Page
Loading...