RC4500 Antenna Controller Chapter 3 Mechanical & Electrical Installation
45
3.4 Board-stack in Outdoor Enclosure w/ Direct Drive to DC Motors
This section describes the mechanical and electrical interfaces of the RC4500 in a weatherproof, outdoor
enclosure.
3.4.1 Mechanical Mounting
The RC4500 is available as a board-stack mounted inside an outdoor weatherproof enclosure. The
following diagram shows the typical dimensions of the outdoor enclosure. The outdoor enclosure can be
directly wall- mounted or mounted to a uni-strut frame using the four mounting flanges that are welded to
the back of the housing.
Dimensions are in inches.
The mounting flanges shown can accept 3/8” diameter bolts (not included.)
To Next Page
Loading...