RC4500 Antenna Controller Chapter 4 Software Configuration / Installation
75
4.3 Final Calibration
4.3.1 Drive System Checkout
This step confirms the configuration of the drive system for all three axes. Manually move the mount to
each axis limit and confirm drive current to the motor is shut off when the limit is reached. Also check the
displayed position value and confirm that it is reasonable.
SETUP (
5.1.2.1) several dummy satellites and RECALL (5.1.2.2) them to check out the automatic drive
system. If the mount does not smoothly move to the target position, the drive parameters may have to be
adjusted.
To Next Page
Loading...
