RC4500 Antenna Controller Chapter 3 Mechanical & Electrical Installation
21
3.0 MECHANICAL & ELECTRICAL INSTALLATION
This chapter describes the RC4500 and common external devices that may be used for integrating an
antenna system. This chapter is split into four main parts. The first part describes the RC4500 in a
standard rack-mount enclosure, interfacing to an AIU. The second part describes the RC4500 in a
standard rack-mount enclosure, directly driving low voltage DC motors. The third part describes the
RC4500 in an embedded, environmentally sealed enclosure, interfacing to an AIU. The fourth part
describes the RC4500 in an embedded, environmentally sealed enclosure, directly driving low voltage DC
motors.
Rack Mount Controller
Motor Drive: via Antenna Interface Unit
Go to Section 3.1
Rack Mount Controller
Motor Drive: Direct Drive to Low-Voltage DC Motors
Go to Section 3.2
Embedded Controller
Motor Drive: via Antenna Interface Unit
Go to Section 3.3
Board-stack installed in Outdoor Enclosure
Motor Drive: Direct Drive to Low-Voltage DC Motors
Go to Section 3.4
To Next Page
Loading...
