RC4500 Antenna Controller Chapter 5 MODES – In Depth Descriptions
88
5.2.1.1 NORMAL ACCESS ITEMS
The configuration groups contained in the “Normal” access level allows the user to change items that
would typically be required to be changed following system configuration.
EXPERT ACCESS: 0 CONFIG-EXPERT
5.2.1.1.1 Expert Access Level
0-NORMAL/1-INSTALL/2-SUPER<5 DIGIT CODE>
The Expert Access level is used to control access to controller modes and configuration items.
The available expert access levels are: SUPER-USER, INSTALL, and NORMAL. The user has access to
all modes and all configuration items when Expert Access is set to SUPER-USER (level 2). The user has
access to all controller modes and general configuration items when Expert Access is set to INSTALL
(level 1). The user is restricted to basic operational modes when Expert Access is set to NORMAL (level
0).
When the Expert Access screen is displayed, the current expert access level is displayed after EXPERT
ACCESS. To change state of the flag, the user must key in a 5 digit code followed by the ENTER key.
This code is found in Appendix A "Expert Access Codes" at the end of this manual. If the information is
lost, call the factory for assistance.
To Next Page
Loading...
