RC4500 Antenna Controller Chapter 5 MODES – In Depth Descriptions
117
5.2.2.2 Drive Error Resets
1-AZIM: JAMMED DRIVE RESET
2-ELEV: RUNAWAY <4>RESET PULSE COUNT
3- POL: OK (AZ/EL AT STOW)
RESET <1-3>AXIS <MODE>EXIT
The DRIVE RESET maintenance screen provides the way to reset drive system errors (JAMMED /
RUNAWAY / DRIVE) for each axis. See the drive system theory section 6.2.3 for descriptions of these
conditions. An axis’ drive status may be reset by pressing the corresponding key.
This screen also provides for resetting the azimuth and elevation pulse counts to their reset state of 32768
for each axis (azimuth and elevation).
To Next Page
Loading...