Retsch Emax - Page 24

First Commissioning
24
NOTICE The coolant consists of cooling liquid and a coolant additive. Only clean, lime-free
water is permitted as cooling liquid. The coolant additive (article no. 02.362.0027) is included
with the delivery of the device and can be ordered separately when required.
 Mix 600 ml of clean, lime-free water with 15 ml of the supplied coolant additive.
 Unscrew the lid (TD) to fill in the coolant.
 Remove the filter insert (FE) from the coolant tank.
 Activate the cleaning mode in the "Settings" menu (→ Chapter "Cleaning Mode").
Fig. 7: Filling the coolant tank: open (left), remove filter insert (right)
 Fill in the coolant in the coolant tank.
 If necessary add more coolant until the fill level is located in the top third, but below the
maximum fill level.
TD
FE
AS