Clean the base (TB) of the coolant tank.
Also clean the previously removed filter insert (FE).
Reinsert the pipe (TR). Ensure the proper fit of the sealing gaskets.
9.3.1.2 Filling New Coolant
NOTICE The coolant consists of cooling liquid and a coolant additive. Only clean, lime-free
water is permitted as cooling liquid. The coolant additive (article no. 02.362.0027) is included
with the delivery of the device and can be ordered separately when required.
Mix 600 ml of clean, lime-free water with 15 ml of the supplied coolant additive.
Fill in the coolant.
Activate the cleaning mode in the "Settings" menu (→ Chapter "Cleaning Mode").
If necessary add more coolant until the level is located in the top third, but below the
maximum fill level.
Deaerate the system (→ Chapter "Commissioning of the Cooling")!
Deactivate the cleaning mode.
Insert the filter insert (FE) again and screw the lid (TD) back onto the coolant tank. Ensure
the proper fit of the sealing gaskets.
NOTICE Check the cooling system regularly for leaks.
To Next Page
Loading...
