Retsch Emax - Packaging, Transport, and Installation

Packaging, Transport and Installation
16
4 Packaging, Transport and Installation
4.1 Packaging
The packaging has been adapted to the mode of transport. It complies with the generally
applicable packaging guidelines.
NOTICE
N3.0001
Complaint or return
Keeping the packaging
− Inadequate packaging and insufficient securing of the device can
jeopardise the warranty claim in the event of a complaint or return.
• Keep the packaging for the duration of the warranty period.
4.2 Transport
NOTICE
N4.0017
Damage to components
Transport
− Mechanical or electronic components may be damaged during transport.
• The device must not be knocked, shaken or thrown during transport.
NOTICE
N5.0014
Complaints
Incomplete delivery or transport damage
− The forwarding agent and Retsch GmbH must be notified immediately in
the event of transport damage. It is otherwise possible that subsequent
complaints will not be recognised.
• Please check the delivery on receipt of the device for its
completeness and intactness.
• Notify your forwarding agent and Retsch GmbH within 24 hours.
4.3 Temperature Fluctuations and Condensation
NOTICE
N6.0016
Damaged components due to condensation
Temperature fluctuations
− The device may be exposed to substantial fluctuations in temperature
during transport. The ensuing condensation can damage electronic
components.
• Wait until the device has acclimatised before putting it into service.
Temporary storage:
Also in case of an interim storage the device must be stored dry and within the specified
ambient temperature range.
4.4 Conditions for the Installation Site