Packaging, Transport and Installation
26
Complaints
Incomplete delivery or transport damage
− The forwarding agent and Retsch GmbH must be notified immediately in
the event of transport damage. It is otherwise possible that subsequent
complaints will not be recognised.
• Please check the delivery on receipt of the device for its
completeness and intactness.
• Notify your forwarding agent and Retsch GmbH within 24 hours.
4.4 Temperature Fluctuations and Condensation
Temporary storage:
In case of an interim storage the device must be stored dry and within the specified ambient
temperature range.
Damaged components due to condensation
Temperature fluctuations
− The device may be exposed to substantial fluctuations in temperature
during transport. The ensuing condensation can damage electronic
components.
• Wait until the device has acclimatised before putting it into service.
4.5 Conditions for the Installation Site
Risk of injury caused by the device falling
Incorrect installation of the device
− Due to its weight, the device can cause injuries if it falls.
• Only operate the device on a sufficiently large, strong and stable
workstation.
• Ensure that all of the device feet are securely supported.
Setting up the device
Vibrations during operation
− Depending on the operating mode of the device, slight vibrations may
occur.
• Set up the device only on a vibration-free, plane and stable surface.
Setting up the device
Disconnecting the device from the mains
− A separation of the device from the mains must be possible at any time.
• Set up the device in such a way, that the connection for the power
cable is always easily accessible.
To Next Page
Loading...