Press the parameter to be edited.
Turn the rotary knob until the desired value is displayed.
Press the parameter again or select another parameter so that the set value is accepted.
Press (S2.3) to save the set parameters.
7.6.3 Save a Programme
7.6.4 Delete a Programme
To delete all parameters of a programme, tap on the button (S1.2).
Confirm the deletion by tapping on the button (S2.2).
Abort with the button (N2.2).
7.7 Cycle programme mode
Press the button in the main menu to switch to cycle programme mode. After switch-on, the
display changes to cycle programme 1; otherwise to the last used cycle programme.
In the cycle programme mode, cycle programmes may be selected, edited, saved, deleted and
started.
If sample materials are frequently ground with the same parameters, these parameters can be
saved in the presets for the cycle programmes and called up as Standard Operating Procedures
(SOP) where required.
Up to four presets are available for the cycle programmes.
The following parameters can be saved in the individual cycle programmes:
• Vibration frequency
• Grinding time
• Cycles (repetitions of grinding time and vibration frequency)
A cycle includes two sets of parameters (A and B). The vibration frequency and grinding time
can be freely selected for each parameter set. The complete cycle programme consists of the
two sets of parameters (A and B) and the set repetitions.
When starting grinding via a cycle programme, the grinding parameters cannot be
changed during the grinding process.
To Next Page
Loading...
