6.8 Starting the grinding process
Start the grinding process as follows:
NOTEThe grinding process may only be started when the grinding points are evenly loaded.
Otherwise, the device may be damaged.
Close the hood (1) carefully by hand.
NOTEThe hood of the device is equipped with damping. The cushioning ensures that the hood
of the device does not slam shut uncontrollably. The damping of the hood of the device takes
effect from an opening angle of 20°.
Configure the parameters for grinding on the touch display (2) and with the rotary knob.
Press on the touch display (2) to start the grinding process. If the touch display does not
show , it is possible that the parameters for the grinding were not fully configured, or the
hood of the device was not closed properly.
Risks of burns and scalding
Hot grinding jar and/or sample material
− The sample material and grinding jar can get very hot during the grinding
process.
• After grinding, always wear protective gloves when handling the
grinding jar.
• Never open hot grinding jars!
• Allow grinding jars to cool down to room temperature before
opening them.
To Next Page
Loading...
