Handling foodstuffs, pharmaceuticals and cosmetic products
Products processed
− Foodstuffs, pharmaceuticals and cosmetic products that have been
processed on the device may no longer be eaten, used or put into
circulation,.
• Dispose of these substances according to applicable directives.
Remove the grinding jar and the material to be ground as follows:
Wait for the grinding process to finish.
Open the hood of the device (1).
ATTENTIONThe grinding jar and the grinding jar holder may have overheated during the
grinding process and may be hot.
Pull the locking pin (6) up out of the groove and turn it by about 60°. This releases the lock. If
the locking pin cannot be moved, it is jammed. In this case, turn the locking wheel back and
forth a little to loosen the locking pin.
Turn the locking wheel (7) on the grinding bowl holder anti-clockwise until the maximum
clamping range is available
Briefly tighten the locking wheel (7) clockwise, after which the locking pin can move freely
again.
Remove the grinding jar by lifting it up and out of the grinding jar holder.
Open the grinding jar by turning the grinding jar lid. Use the opening aid if necessary.
Lift off the grinding jar lid. Keep the grinding jar upright, as the contents may fall out upon
opening.
Remove the sample material from the grinding jar.
To Next Page
Loading...
