Retsch MM 400 - Date and Time; Service Environment; Software Update

Device control
65
7.8.5 Date and time
Proceed as follows to adjust the date and time:

Press the section.

Select the desired settings using the dial.

The set values will be accepted as soon as you press this section again or on another
section, or as soon as you exit system settings.
7.8.6 Service Environment
In this section, the following information can be viewed:
• Service and connection information
• Software update
• Calibration
The connection information contains relevant information for the service technicians of the
Retsch GmbH.
Fig.39: Device information
Element
Function
SE6.1
Service and connection
information
Information for the service department.
SE6.2
Software updates
Software update of the device via a USB data medium.
SE6.3
Calibration
Information on calibrating the device.
7.8.6.1 Software update
To update the software, proceed as follows:
Insert the USB data medium into the USB interface.
Press the icon to carry out the update.
Wait for the transfer and installation to complete.
The background of the rotary knob flashes blue until the touch display has restarted. This may
take a few seconds.
A suitable USB data carrier must be connected to the USB interface.
• The USB data medium must be formatted in the FAT32 file system.
SE6.1
SE6.2
SE6.3