Retsch MM 400 - Select a Program

Device control
55
Fig. 27: Programme mode after starting the grinding process
Element
Function
N1.2
Main menu
Opening the main menu.
N3.2
Gallery view
Opens the gallery view for the programmes or the available
programme presets.
P1N
Programme number
Number of the selected programme.
P1.1
Vibration frequency
After selection with the touch display, the rotary knob can
be used to set the vibration frequency from 3 - 30Hz
(invalid values are displayed in red text).
P2.1
Grinding time
After selection with the touch display, the grinding time can
be set from 10 seconds to 8 hours with the rotary knob
(invalid values are displayed in red text).
P2.2
Remaining grinding time
Shows the remaining grinding time for the current grinding
process.
B
Scrollbar
Indicator for the position of the menu.
S2.1
Pause grinding process
Stops the grinding process. By pressing again, the grinding
process is continued.
S2.2
Editor mode
Opens the programme editor.
S3.1
Start grinding process
Starts the grinding process (this button is only visible after
setting valid parameters).
S3.2
Stop grinding process
Stops the grinding process.
7.6.1 Select a Program
In the programme mode, programmes with preset parameters for the grinding process can be
selected. To select a programme, press the button (N2.1) in the main menu. The respective
programme number is displayed next to the symbol (P1N).
After starting the device, the programme view always opens with programme 1 in the individual
view.
P2.2
S3.2
S2.1