18/44
Bosch Rexroth Canada ı May.2018 ı Revision 7.0
13 Load Parameters
The operation requires an USB PROGRAM key. It allows end users to load parameters
from an existing file on the USB stick.
1. Ensure an USB PROGRAM key inserted
2. Tap on USB symbol.
3. Select a file to load from the popup file window.
4. Click on the “Select” or “Cancel” button to select or cancel.
Then the popup file window would close, and red “Load” text shows up on the USB
symbol if a file is selected.
5. Tap on the Door Symbol to exit to the operation mode.
6. Turn the unit off, and on again for the new parameter to take effect.
To Next Page
Loading...
Need help?
General
