ASMxxxx Series User’s Manual
Asia Pacific | EMEA | Americas 145
axmAlarmStatusBits
OID 1.3.6.1.4.1.32327.2.2.2.1.2.4
Syntax Integer 0..65535 (i.e. 16 bits)
Description This is an integer value representing the status bits relevant to the alarm type.
The various sets of status bits are detailed as follows;
ReStart
These bits will generally be the same as the System Status Bits, but because the system has only just restarted
they will likely not be fully up to date representing the true system status. They should therefore be ignored.
SystemStatus
System Status Bits
The system summary status bits are:
0x0001 Lock detect fail for Receive synthesisers.
0x0002 Lock detect fail for Transmit synthesisers.
0x0004 One or more Tx Power level fails are present.
0x0008 One or more Tx VSWR fails are present.
0x0010 Rx Power level fail is present.
0x0020 System hardware alarms summary. (See Hardware Alarm Bits)
0x0040 Antenna Isolation test fail is present.
0x0080 One or more CAM/SAM External or General Purpose DI alarms are present.
0x0100 Rx Summary alarm.
0x0200 Tx Power summary alarm.
0x0400 Tx VSWR summary alarm.
0x0800 Not in use.
0x1000 Not in use.
0x2000 Receive Systems Module alarm.
0x4000 Alarm relay is active. As masked by Alarm Config.
0x8000 Summary alarm LED is active.
Hardware Alarm Bits
0x01 Internal 5V rail is out of limit.
0x02 Internal temperature exceeds 80 degrees.
0x04 Internal hardware failure – I2C EEPROM.
0x08 Internal hardware failure – SFLASH.
0x10 Internal hardware failure – SD-Card.
Note: These are not presented separately, but any Hardware Alarm Bit(s) will set the 0x0020 bit of the
(above) System Status Bits.
Channel Status
Note: Decoded from the following tables and is based on determining a RX or Tx message from the contents
of the rest of the SNMP trap message.
Rx Status Bits
0x0001 Rx power level fail summary.
0x0002 Rx Antenna isolation loss fail summary.
0x0004 RxA level out of range (Rx-0 only).
0x0008 VCO lock fail.
0x0010 RxB level out of range (Rx-0 only).
0x0020 Any Rx signal still ON/OFF.
0x0040 RxE level out of range (Rx-0 only).
0x0080 RxA signal present.
0x0100 RxB signal present.
0x0200 RxE signal present.
0x0400 RxA enabled.
0x0800 RxB enabled.
0x1000 RxE enabled.
0x2000 RSM Present.
To Next Page
Loading...
General