ASMxxxx Series User’s Manual
Asia Pacific | EMEA | Americas 93
ALM O/P:
The Alarm Output that this channel’s Min. Pwr or Max. Pwr alarm has been assigned to.
Note: This is configured in the Configuration – Alarm Settings – System or Configuration – Alarm Modules screens as
required.
Defaults:
Clicking this button enters the factory default values for the Channel alarm settings, which are;
Min Power -110dBm
Max Pwr -75dBm
Discard Changes:
Click this button to restore the values to those present when the page was last displayed.
Note: If invalid values are being displayed after an Apply attempt, these values may not match the current system
configuration. In this case, just select the relevant Configuration/Alarms/Rx Channels menu item again to re-display
the current configuration.
Apply:
This will attempt to save and activate the values entered. If any out of range values are present, nothing will be saved and the
problem settings will be highlighted with a red background.
Note: Whenever any configuration changes are applied, the alarm status for affected channels is re-initialised.
To Next Page
Loading...
General