Ricoh 2555 - Auto Reset

Copying
32
2
Note
❒ The maximum copy quantity can be set between 1 and 999 (default: 999).
See “Maximum Copy Quantity” in ⇒ p.295 “General Features
2
/
3
”.
❒ To change the number entered, press the {
{{
{Clear/Stop}
}}
} key and enter the
new number.
G
GG
G
Press the {
{{
{Start}
}}
} key.
The machine starts copying.
Note
❒ When you set originals on the exposure glass, press the {
{{
{#}
}}
} key after all
originals are scanned.
❒ Usually, when you set a single original on the exposure glass or in the doc-
ument feeder, the copied paper is delivered face up. However, with some
functions, copies will be delivered face down.
❒ You can choose to have copies delivered either face up or face down (ex-
cept for copying through the bypass tray). See “Face-Up/Down Selection
in Platen Mode” in ⇒ p.309 “Input/Output”.
❒ To stop the machine during the multi-copy run, press the {
{{
{Clear/Stop}
}}
} key.
❒ To return the machine to the initial condition after copying, press the {
{{
{Clear
Modes/Energy Saver}
}}
} key.
-
--
-Auto Reset
The machine returns to its initial condition automatically when your job is fin-
ished, after a certain period of time. This function is called “Auto Reset”.
Note
❒ You can change the Auto Reset time. See “Auto Reset Timer” in ⇒ p.292
“General Features
1
/
3
”.
-
--
-Auto Off
The machine turns itself off automatically after your job is finished, after a cer-
tain period of time. This function is called “Auto Off”.
Note
❒ You can change the Auto Off time. See “Auto Off Timer” in the System Set-
tings manual.