Copier / Document Server Features
96
3
Edit
This section describes the user tools in the Edit menu under Copier / Document
Server Features.
Enter the width of the binding margin with the number keys as follows:
• Metric version: 0–30 mm (in increments of 1 mm)
• Inch version: 0”-1.2” (in increments of 0.1 inch)
Enter the width of the erased margin with the number keys as follows:
• Metric version: 2–99 mm (in increments of 1 mm)
• Inch version: 0.1”-3.9” (in increments of 0.1 inch)
An image of approximately 1.5 mm (0.06”) will not be displayed as the width of
the separation line, when specifying solid or broken lines.
❖ Front Margin: Left/Right
Specify left and right margins on the front side of copies in Margin Adjust-
ment mode.
• Left
• Right
Default:
•Metric version: Left 5 mm
• Inch version: Left 0.2”
❖ Back Margin: Left/Right
Specify left and right margins on the back side of copies in Margin Adjust-
ment mode.
•Left
• Right
Default:
•Metric version: Left 5 mm
• Inch version: Left 0.2”
❖ Front Margin: Top/Bottom
Specify top and bottom margins on the front side of copies in Margin Adjust-
ment mode.
•Top
•Bottom
Default:
•Metric version: Top/Bottom 0mm
• Inch version: Top/Bottom 0.0”
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
