Forwarding
143
4
Forwarding
Print documents received and forward to a specified End Receiver. This is useful
if, for example, you are visiting another office and would like a copy of your doc-
uments to be sent to that office.
You can also specify a “folder” as the forwarding destination.
Important
❒ To use this function, set Forwarding under Reception Settings to On (enable).
❒ You can select end receivers only from among destinations programmed in
the Address Book. You cannot specify programmed transfer stations as end
receivers.
A fax number, e-mail address, IP-Fax destination, and folder can be set as the
forwarding destination.
Even when [On] is selected for “Forwarding” in “Reception Settings”, if [Off] is
selected for the forwarding destination in this function, only printing is per-
formed, not forwarding.
When you wish to change the end receivers depending on the senders, specify
the end receivers by the senders, at “Program Special Sender”. Documents not
received from specified senders are sent to the destination specified in this func-
tion.
Specify whether or not to print forwarded documents. See “Parameter Set-
tings”(switch 11, bit 6).
Deleting a destination specified as a forward destination from the destination
list causes the settings of the forward destination to be deleted, so they must be
registered again. When a destination is changed, a document is transmitted to
the new destination. If there is no destination of the specified type, you can set
which destination to be used as an alternative destination. See “Parameter Set-
tings” (switch 32, bit 0).
You can program one of the Quick Operation keys with operations for this func-
tion.
If you have specified a folder for forwarding, you can specify the file format
used for forwarding. See “Parameter Settings” (switch 21, bit 3).
Reference
p.117 “General Features”
p.147 “Parameter Settings”
p.124 “Reception Settings”
p.154 “Special Senders to Treat Differently”
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
