Copier / Document Server Features
106
3
User Stamp
This section describes the user tools in the User Stamp menu under Stamp.
❖ Program/Delete Stamp
You can register, change, or delete these designs as user stamps.
You can register up to four custom stamps with your favourite designs.
❖ Stamp Format:1-4
Specify how each of registered User Stamps 1 to 4 is printed.
•Stamp Position
Specify where to print the User Stamp.
•Top Left
•Top Centre
• Top Right
• Centre Left
•Centre
• Centre Right
•Bottom Left
•Bttm Centre
• Bottom Right
•Stamp Position
You can adjust the position of the User Stamp within the available range
as shown below.
•Metric version:
“Top Left”…T/B: 4-144mm, L/R: 4-144mm
“Top Centre”…T/B: 4-144mm, L/R: 72-72mm
“Top Right”…T/B: 4-144mm, L/R: 4-144mm
“Centre Left”…T/B: 72-72mm, L/R: 4-144mm
“Centre”…T/B: 72-72mm, L/R: 72-72mm
“Centre Right”…T/B: 72-72mm, L/R: 4-144mm
“Bottom Left”…T/B: 4-144mm, L/R: 4-144mm
“Bttm Centre”…T/B: 4-144mm, L/R: 72-72mm
“Bottom Right”…T/B: 4-144mm, L/R: 4-144mm
• Inch version:
“Top Left”…T/B: 0.1”-5.7”, L/R: 0.1”-5.7”
“Top Centre”…T/B: 0.1”-5.7”, L/R: 2.8”-2.8”
“Top Right”…T/B: 0.1”-5.7”, L/R: 0.1”-5.7”
“Centre Left”…T/B: 2.8”-2.8”, L/R: 0.1”-5.7”
“Centre”…T/B: 2.8”-2.8”, L/R: 2.8”-2.8”
“Centre Right”…T/B: 2.8”-2.8”, L/R: 0.1”-5.7”
“Bottom Left”…T/B: 0.1”-5.7”, L/R: 0.1”-5.7”
“Bttm Centre”…T/B: 0.1”-5.7”, L/R: 2.8”-2.8”
“Bottom Right”…T/B: 0.1”-5.7”, L/R: 0.1”-5.7”
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
