Connecting the Machine
20
1
Note
❒ In [Effective Protocol], check that the protocol you want to use is set to [Active].
❒ [IEEE 802.11b] and [LAN Type] are displayed when the wireless LAN interface
board is installed. If both Ethernet and wireless LAN (IEEE 802.11b) are con-
nected, the selected interface takes precedence.
❒ [SMTP Server] and [Fax E-mail Account] must be specified in order to use the
send function.
❒ When [POP before SMTP] is set to [On], also make setting for [Reception Protocol]
and [POP3 / IMAP4 Settings].
❒ When [SMTP Authentication] is set to [On], also make setting for [Administrator's
E-mail Address].
❒ [E-mail Communication Port] and [Fax E-mail Account] must be specified in order
to use the reception function.
❒ When setting [POP before SMTP] to [On], check[POP3] port number in [E-mail
Communication Port].
Reference
p.56 “Interface Settings”
p.66 “File Transfer”
Settings Required to Use E-mail Function
This section lists the settings required for sending e-mail.
Ethernet
This section lists the settings required for sending e-mail with Ethernet cable.
For details about how to specify the settings, see “Interface Settings” and “File
Transfer”.
Menu User Tool Setting Requirements
Interface Settings/Network
Machine IPv4 Address Neccessary
Interface Settings/Network
IPv4 Gateway Address Neccessary
Interface Settings/Network
DNS Configuration As required
Interface Settings/Network
DDNS Configuration As required
Interface Settings/Network
Domain Name As required
Interface Settings/Network
WINS Configuration As required
Interface Settings/Network
Effective Protocol Neccessary
Interface Settings/Network
Ethernet Speed As required
Interface Settings/Network
LAN Type Neccessary
Interface Settings/Network
Permit SNMPv3 Communication As required
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
