Connecting the Machine
30
1
Settings Required to Use Network TWAIN Scanner
This section lists the settings required for using TWAIN Scanner under the net-
work environment.
Ethernet
This section lists the settings required for using network TWAIN Scanner with
Ethernet cable.
For details about how to specify the settings, see “Interface Settings”.
Note
❒ In [Effective Protocol], check that the protocol you want to use is set to [Active].
❒ [LAN Type] is displayed when the wireless LAN interface board is installed.
When both Ethernet and wireless LAN (IEEE 802.11b) are connected, the se-
lected interface takes precedence.
Reference
p.56 “Interface Settings”
Menu User Tool Setting Requirements
Interface Settings/Network
Machine IPv4 Address Neccessary
Interface Settings/Network
IPv4 Gateway Address As required
Interface Settings/Network
DNS Configuration As required
Interface Settings/Network
DDNS Configuration As required
Interface Settings/Network
Domain Name As required
Interface Settings/Network
WINS Configuration As required
Interface Settings/Network
Effective Protocol Neccessary
Interface Settings/Network
LAN Type Neccessary
Interface Settings/Network
Ethernet Speed As required
Interface Settings/Network
Permit SNMPv3 Communication As required
Interface Settings/Network
Permit SSL/TLS Communication As required
Interface Settings/Network
Host Name As required
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
