If you select [Custom Size], proceed to steps 9 and 11 to 14.
9. Select the size you want to program.
If you select [Regular Size], select a paper size displayed, and then proceed to step 14.
If you select [Custom Size], proceed to step 11.
10. Select the size you want to program from the sizes shown.
11. Make sure that [Vertical] is selected.
12. Enter the vertical size of the paper using the number keys, and then press the [ ] key.
Specify a vertical size from 100 mm (4.0") to 305 mm (12.0"). You cannot enter a size smaller than
90 mm or larger than 305 mm.
Each time you press [mm] or [inch], the units switch between "mm" and "inch".
If you enter a length and change the units by pressing [mm] or [inch], it is converted automatically
(fractions are rounded off).
4. Facsimile Features
206
To Next Page
Loading...
