To change the protocol
This section describes how to change the protocol.
1. Press [SMB] or [FTP].
2. A confirmation message appears. Press [Yes].
Changing the protocol will clear all settings made under the previous protocol.
3. Enter each item again.
• p.282 "Using SMB to Connect"
• p.288 "Using FTP to Connect"
Deleting an NCP Folder
This section describes how to delete the registered NCP folder.
1. Press [System Settings].
2. Press [Administrator Tools].
3. Press [Address Book Management].
4. Check that [Program / Change] is selected.
7. Registering Addresses and Users for Facsimile/Scanner Functions
298
To Next Page
Loading...
