Correcting the Color Gradation
This section describes correcting the color gradation.
Color gradation during color printing can change slightly, depending on a number of factors. If you print
the same file repeatedly or print cartridge was recently replaced, changes may occur in color tones. In
such cases, you can obtain optimal print results by correcting the color gradation.
Corrections to color gradation are performed in the following order:
1. Print gradation correction sheet 1.
2. Adjust the parts of highlight colors.
Set the correction value.
Print the gradation correction sheet, and then check the result of the correction.
3. Print gradation correction sheet 2.
4. Adjust the parts of middle colors.
Set the correction value.
Print the gradation correction sheet, and then check the result of the correction.
5. Save the correction value.
• This procedure is not necessary for general printing.
• Color deviation can occur if the machine has not been used for a long time.
• If suitable results cannot be obtained after a single operation, repeat the correction several times, as
needed.
• Corrections to color gradation will be applied to all user jobs.
• Use the same type of paper when printing a run of gradation corrections. If a different type of paper
is used, corrections may not be apparent.
Setting the Gradation Correction Value
The following procedure describes adjusting the gradation correction value.
During printing, you can correct the gradation in two areas: bright part (highlight) and the medium (middle).
The correction values for the highlight and the medium parts are set using [Print Test Pattern 1] and [Print
Test Pattern 2] respectively.
Correcting the Color Gradation
191
To Next Page
Loading...
Need help?
General
