• Confirm that the interface board was correctly installed by printing the configuration page. If it is
correctly installed, "Wireless LAN" will appear for "Device Connection" on the configuration page.
• If the board was not installed properly, repeat the procedure from step 4. If it cannot be installed
correctly even after reattempting installation, contact your sales or service representative.
• For details about printing the configuration page, see "Test Printing".
• Before using the Wireless LAN interface board, you must configure settings from the printer control
panel. For details, see "Wireless LAN Configuration".
• p.43 "Test Printing"
• p.88 "Wireless LAN Configuration"
Installing the IEEE 1284 Interface Board
• Before beginning work, ground yourself by touching something metal to discharge any static
electricity. Static electricity can damage the IEEE 1284 interface board.
• Do not subject the IEEE 1284 interface board to physical shocks.
• For connection to the IEEE 1284 interface board, use a half pitch 36-pin interface cable.
3. Installing Options
62
To Next Page
Loading...
