For details about installing the unit, see p.57 "Installing the Interface Units".
Problem:Wireless card Please call service.
The printer cannot detect a Wireless LAN board. It may be incorrectly installed.
Check if it is installed properly or contact your sales or service representative.
For details about installing the unit, see p.57 "Installing the Interface Units".
Replacement Alert Replace Transfer Belt.
You need to replace the intermediate transfer unit. Contact your sales or service representative to obtain
a new intermediate transfer unit.
See p.161 "Replacing the Intermediate Transfer Unit".
Replacemnt Requird:IntTrans
You need to replace the intermediate transfer unit. For details, see p.161 "Replacing the Intermediate
Transfer Unit".
Replacmnt Rqrd:Fusing Unit
You need to replace the fusing unit. For details, see p.172 "Replacing the Maintenance Kit".
Replcmnt Requrd: Print Cart
The toner has run out, or the photo conductor unit has reached the end of its service life. Replace the print
cartridge. For details, see p.147 "Replacing the Print Cartridge".
Replcmnt Rqrd Soon:IntTrans
You will need to replace the intermediate transfer unit soon. Contact your sales or service representative
to obtain a new unit.
Repl Requrd Soon:FusingUnit
You will need to replace the fusing unit soon. Contact your sales or service representative to obtain a new
unit.
Repl Soon:Prt.Cart.
The toner has almost run out, or the photo conductor unit is nearing the end of its service life. Obtain a new
print cartridge.
SD Card authenticatn.failed Error recurs, call service.
Authentication from the SD card failed. Turn the power off, and then back on. If the error recurs, contact
your sales or service representative.
Sensor cleaning required.
You need to clean the toner density sensor.
For details, see p.180 "Cleaning the Toner Density Sensor".
Error and Status Messages Appear on the Control Panel
205
To Next Page
Loading...
Need help?
General
