Ricoh DD 4450 - 2 X SP Mode Table: Thermal Head (T;H) Energy Control

SP Table
C279 14 SM Appendix
2-50
T/H swinging mode
[ ON-OFF / OFF / -]
Sets whether to enable the shift of the thermal head writing position.
 ON: Shift the values specified in the SP2-51(T/H swinging quantity).
2-51
T/H swinging quantity
[±1 to 5mm / 2 / -]
Set the shift amount of the thermal head writing position.
2-52
T/H Control by Temp: Color
(Fine)
[ ON-OFF / ON / -]
Set the ink temperature correction in the color ink density mode.
 OFF: Temperature inside the drum takes a constant value irrespective.
2-53
T/H Control by Temp: Black
(Fine)
[ ON-OFF / ON / -]
Set the ink temperature correction in the black ink density mode.
 OFF: Temperature inside the drum takes a constant value irrespective.
2-54
T/H Energy Control: (Fine)
[ 0 to 50% / 7 / 1%-]
Initial value is 7%.In this case, that means thermal head energy can be up to
93% in printing mode(density) (100-7=93%).
2-55
T/H Energy Control -Eco (Fine)
[0 to 50 / 15 / 1%]
Initial value is 15%.In this case, in economy printing mode (density) means that
an additional 15% reduction will be thermal head energy. Thermal head energy
in 78% maximum. (100-7-15=78%)
2-56
T/H Control by temp: A4 (Fine)
[ ON-OFF / ON / -]
Set the ink temperature correction in the A4 drum density mode.
 OFF: Temperature inside the drum takes a constant value irrespective.