Ricoh E-25C - Safety; Prevention of Physical Injury

For Norway
This product is also designed for an IT power distribution system with phase-to-phase voltage 230V.
Safety
Prevention of Physical Injury
1. Before disassembling or assembling parts of the machine and peripherals, make sure that the
machine and peripheral power cords are unplugged.
2. The plug should be near the machine and easily accessible.
3. Note that some components of the machine are supplied with electrical voltage even if the main
power switch is turned off.
4. Always unplug the power cord from the power source before you move the product. Before you
move the machine, arrange the power cord so it will not fall under the machine.
5. If any adjustment or operation check has to be made with exterior covers off or open while the main
switch is turned on, keep hands away from electrified or mechanically driven components.
6. The machine drives some of its components when it completes the warm-up period. Be careful to
keep hands away from the mechanical and electrical components as the machine starts operation.
7. To prevent a fire or explosion, keep the machine away from flammable liquids, gases, and
aerosols.
8. Do not use flammable sprays or solvent in the vicinity of the machine. Also, avoid placing these
items in the vicinity of the machine. Doing so could result in fire or electric shock.
9. To avoid fire or explosion, never use an organic cleaner near any part that generates heat.
10. Never remove any safety device unless it requires replacement. Always replace safety devices
immediately.
11. Never do any procedure that defeats the function of any safety device.
12. Modification or removal of a safety device (switch, etc.) could lead to a fire and personal injury.
Always test the operation of the machine to ensure that it is operating normally and safely after
removal and replacement of any safety device.
13. For replacements use only the correct circuit breakers rated for use with the machine. Using
replacement devices not designed for use with the machine could lead to a fire and personal
injuries.
14. When using a vacuum cleaner around the machine, keep others away from the cleaner, especially
small children.
15. NEVER touch the AC circuits on the PSU board to prevent electric shock caused by residual
charge. Residual charge of about 100V-400V remains in the AC circuits on the PSU board for
several months even when the board has been removed from the machine after turning off the
machine power and unplugging the power cord.