Ricoh FAX2000L - Page 108

30 November, 1999 NCU PARAMETERS
4-41
Service
Tables
Address Function Unit Remarks
807F49 Country dial wait interval (high) 20 ms
807F4A
Time between opening or closing
the Ds relay and opening the Di
relay
1 ms
See Notes 4 and 7.
Function 08 (parameter
11).
807F4B Break time for pulse dialing 1 ms See Note 4. Function 08
(parameter 12).
807F4C Make time for pulse dialing 1 ms See Note 4. Function 08
(parameter 13).
807F4D Time between final Di relay closure
and Ds relay opening or closing
1 ms See Notes 4 and 7.
Function 08 (parameter
14).
807F4E Minimum pause between dialed
digits (pulse dial mode)
20 ms See Note 4. Function 08
(parameter 15).
807F4F Time waited when a pause is
entered at the operation panel
Function 08 (parameter
16). See Note 4.
807F50 DTMF tone on time 1 ms Function 08 (parameter
17).
807F51 DTMF tone off time Function 08 (parameter
18).
807F52
Tone attenuation level of DTMF
signals while dialing
(high frequency group)
-dBm x
0.5
Function 08 (parameter
19). See Note 6.
807F53 Tone attenuation value difference
between high frequency tone and
low frequency tone in DTMF
signals
-Nx0.5
(dB)
Function 08 (parameter
20). See Note 6.
807F54
PSTN: DTMF tone attenuation level
after dialing
(high frequency group)
-dBm x
0.5
Function 08 (parameter
21). See Note 6.
807F55
to
807F58
Not used Do not change these
settings.
807F59 Grounding time (ground start
mode)
20 ms The Gs relay remains
closed for this interval.
807F5A Break time (flash start mode) 1 ms
The OHDI relay is open for
this interval.
807F5B
807F5C
International dial access code BCD For a code of 100:
807F5B - F1
807F5C - 00
807F5D PSTN access pause time 20 ms It waits this amount of time
for each pause input after
the PSTN access code. Up
to 7 of these can be input.
If this address contains
FF[H], the pause time
stored in address 807F4F
is used.