SERVICE LEVEL FUNCTIONS 30 November, 1999
4-10
3. Turn on the machine.
4.
'6
ç
ì
ä
ä
å
then immediately press
:
5.
ì
ë
:
6.
á
é
7.
4
If the software downloads successfully, the
display shows "
OK
".
If the software download fails, the display
shows "
CANNOT PROGRAM
".
8. To finish, press
'6
.
9. Turn off the machine and disconnect the tool. Then turn the machine back on.
10. Print out the system parameter list and check the ROM version on it.
4.1.23 SOFTWARE UPLOAD (FUNCTION 12)
This function copies the software from the FCU inside the machine to an external
FCU.
1. Turn off the machine.
2. Connect the Flash/SRAM Copy Tool and an FCU as shown in the previous
section.
NOTE:
The switch [D] on the tool must be at the
OFF
position.
3. Turn on the machine.
4.
'6
ç
ì
ä
ä
å
then immediately press
:
5.
ì
ë
:
FUNCTION KPAD/NEXT>
■■SERVICE FUNCTIONS
0-SRAM 1-SAF
2-SAFCARD 3-M->R
OK!!
COPY MACH <- FLROM
COPYING
CANNOT PROGRAM
FUNCTION KPAD/NEXT>
■■SERVICE FUNCTIONS
0-SRAM 1-SAF
2-SAFCARD 3-M->R